Vape & Make

Important note: The battery holder offered here is not a product of the company "Keystone". The holder comes from "Blossom Electronics", the contacts from Keystone. We have combined both into our own product and sell this under the brand "Vape & Make".

• Battery holder for 2 x 18650 lithium ion cells
• Made of nylon by injection molding
• Contacts 4 x Keystone 1107-1 slide-in contact with solder lug

• All required components.
• EVOLV DNA 250 color Board with reverse polarity protection.
• EVOLV DNA 75 color Board with reverse polarity protection.
• Designed for 2 batteries in series connection (2S).
• Outer dimension 89 x 61 x 28, inner dimension 84 x 57 x 24 mm

Technical construction

• 2 x 18650 battery, in series connection.
• EVOLV DNA 250 color Board with reverse polarity protection.
• EVOLV DNA 75 color Board with reverse polarity protection.
• 22mm Top Cap.
• Chip holder glued in box (not screwed).

Documentation and Downloads

• Technical manual DNA 250C.
• Technical manual DNA 250C.
• Configuration software Escripe.

Included components

• Box: Analog Box Mods V2 incl. magnets.
• 510s: Fat Daddy Vapes / ModMaker / Steathvape.
• Control: Eolv DNA 250C.
• Controller: Eolv DNA 75C.
• Chip holder: Vape & Make 3D laser sinter print.
• Button: Analog Box Mods.
• Battery holder: Vape & Make 2 x 18650, right side ground.
• Battery holder contacts: Keystone 4 x 1107-1.
• Cables: silicone high flex, 2 x 15cm each of 14 AWG, 16AWG and 24 AWG.
• +/- Warning stickers: Fat Daddy Vapes, 4 pieces.