The build kit for the TLF# Squonker (Includes all components except box, door, button and lock ring).
Developed in collaboration between TLF# and Vape & Make and manufactured at the respective specialist in Spain, England, USA and Germany. Available now as a complete kit but also in individual components.
The box itself (door, button, lock ring) can still be found in the usual place at Shapeways with the search term "TLF#" Everything else you need for this popular Sqounker can be found in the kit.
Starting with the copper plates over the 510 and the bottle to the magnet and a satin ribbon for easier removal of the battery. As an addition the Coil Master microfiber cloth to clean the squonker.
Order at Shapeways and here, assemble according to the enclosed instructions, screw on the vaporizer, fill with liquid and you too can enjoy the TLF#.
Product safety information
Manufacturer information:
Vape & Make
Tueleck 8
48336 Sassenberg,
Nordrhein-Westfalen, Deutschland
info@vapeandmake.com
https://vapeandmake.com
There are a few things to bear in mind. But perhaps you have already discovered the ATTENTION notes on Shapeways.com.
- Remove any remaining dust from the inside (under the bottom of the bottle & battery strap slot)
- make sure that the button can move freely
- possibly widen the 510 hole
- Scorch the battery strap on one side with a lighter until it jams in the slot
Installation sequence
- First comes the 510.
- First snap in the positive terminal plate until it fits snugly and clicks into place (do not bend it quite 90 degrees so that you get enough pressure on the button)
- Screw in the negative pole plate with 510 body (without core) halfway so that you have enough play to get the core past the plate.
- Insert the battery so that there is pressure on the positive terminal plate and the button is in the final position.
- Lift the sheet metal (just enough so that the button flies past)
- Fit the button with very thin double-sided adhesive and lower the sheet metal.
- REMOVE THE BATTERY !!!
- Install the core (shorten the pin for 8.5 mm bottles beforehand)
- Tighten the 510 (it's best to counter the nut and tighten it with an old Atty instead of fiddly tightening the nut with needle-nose pliers)
- Have fun!
