Other manufacturers and accessories
Other manufacturers and accessories
Items 1 - 10 of 12
- The best MOSFET for moderators and makers
- Allows the use of any fire button. Also recommended as a safety device for high-amp fire switches.
- The required 15K Ohm resistor is also included.
- Alternatively with one or two MHP-TA15-9-72 fuses.
- This trips at 75°C and opens again when it gets colder
- Only 1/2 inch diameter .
- Made of heat resistant materials .
- An optimal component, not only for box mods .
- Five different colors .
- Fine adjustment via mini potentiometer on the back .
- Reverse polarity protection .
- 2.4 to 30 volts.
- Suitable for the usual voltmeters used in mod construction
- Made of 6061 aluminum, anodized
- External dimensions: 30 x 18 x 4 mm
- Internal dimensions: 25 x 13 x 3 mm Voltmeter shown is not included in the scope of delivery
- Rated at 35A - 45A
- Zero idle drain
- Onboard LED
- Smooth vaping experience
- 1S to 4S compatible (2.7v to 18v)
- Suitable for the usual "93PR" pots from TT Electronics .
- Made of 6061 aluminum, anodized .
- Radius inside: 13.07 mm, outside: 18.09 mm, height 4.03 mm .
- Potentiometer shown is not included in the scope of delivery.
- Four different colors .
- Fine adjustment via mini potentiometer on the back .
- Reverse polarity protection .
- 0 to 100 volts .
- Resolution below 10V 0.01, above 10 volts 0.1.
- Fuse triggers at a temperature of 72°C.
- It resets automatically as soon as the temperature falls below 40°C.
- The fuse is designed for a continuous load of 15 amps.
- If more power is required, simply connect 2 fuses in parallel.
- Under voltage lockout at 2.9v. .
- Blue LED when firing. .
- Provision for easy installation of remote switch. .
- Tested down to 0.15ohm builds on 2P .
- 4 mount points which can be removed to make it ultra tiny. .
- Documents from the manufacturer: Google Drive .
- Link to the manufacturer: Voltrove.
Items 1 - 10 of 12