Other manufacturers and accessories
Items 1 - 8 of 8
- Four different colors .
- Fine adjustment via mini potentiometer on the back .
- Reverse polarity protection .
- 0 to 100 volts .
- Resolution below 10V 0.01, above 10 volts 0.1.
- Five different colors .
- Fine adjustment via mini potentiometer on the back .
- Reverse polarity protection .
- 2.4 to 30 volts.
- Suitable for the usual voltmeters used in mod construction
- Made of 6061 aluminum, anodized
- External dimensions: 30 x 18 x 4 mm
- Internal dimensions: 25 x 13 x 3 mm Voltmeter shown is not included in the scope of delivery
- Suitable for the usual "93PR" pots from TT Electronics .
- Made of 6061 aluminum, anodized .
- Radius inside: 13.07 mm, outside: 18.09 mm, height 4.03 mm .
- Potentiometer shown is not included in the scope of delivery.
Best sellers
- The best MOSFET for moderators and makers
- Allows the use of any fire button. Also recommended as a safety device for high-amp fire switches.
- The required 15K Ohm resistor is also included.
- Alternatively with one or two MHP-TA15-9-72 fuses.
- This trips at 75°C and opens again when it gets colder
- Fuse triggers at a temperature of 72°C.
- It resets automatically as soon as the temperature falls below 40°C.
- The fuse is designed for a continuous load of 15 amps.
- If more power is required, simply connect 2 fuses in parallel.
- The new board from Etileno. Now also with display
- For 2, 3 or 4 batteries (2S, 3S, 4S) and up to 40 amps
- Protection functions: Reverse polarity, low battery, short circuit, 10s automatic shutdown, vaporizer no contact
- Control via button or potentiometer possible
- Operation without display possible .
Items 1 - 8 of 8