Accessories

• Printed by means of laser printing (SLS)
• Precise fit manufacturing, nothing wobbles here.
• To install, insert the chip / display into the holder. Then carefully press on the other side to full width (use both hands).

Included components

• Combined chip / battery holder: Vape & Make
• Insulation box bottom: Vape & Make
• Battery contacts: Keystone
• Solder lug: Rosenberger

• Four push buttons for Evolv DNA boards. One large power button (Ø 8mm) and three small control buttons (Ø 4mm)
• Length optimized for boxes with a wall thickness of 2mm
• Three different colours/materials: silver (stainless steel), black (anodized aluminium), golden yellow (brass)

• Special tool from Fat Daddy Vapes
• On the one hand a drill for the 510 hole
• On the other hand a tap for the 510 thread
• So the 510 sits absolutely tight
• Also for boxes with already existing 510 hole

• Fits the usual "93PR" pots from TT Electronics .
• Made of 6061 aluminum, anodized .
• Radius inside: 13,07 mm, outside: 18,09 mm, height 4,03 mm .
• Pictured potentiometer is not included.

• Fits the usual voltmeters in mod building.
• .
• made of 6061 aluminum, anodized
• .
• outside dimensions: 30 x 18 x 4 mm
• .
• inside dimensions: 25 x 13 x 3 mm
Voltmeter shown does not belong to the scope of delivery