Other manufacturers and accessories
Items 1 - 6 of 6
Best sellers
- The best MOSFET for moderators and makers
- Allows the use of any fire button. Also recommended as a safety device for high-amp fire switches.
- The required 15K Ohm resistor is also included.
- Alternatively with one or two MHP-TA15-9-72 fuses.
- This trips at 75°C and opens again when it gets colder
- Only 1/2 inch diameter .
- Made of heat resistant materials .
- An optimal component, not only for box mods .
- Fuse triggers at a temperature of 72°C.
- It resets automatically as soon as the temperature falls below 40°C.
- The fuse is designed for a continuous load of 15 amps.
- If more power is required, simply connect 2 fuses in parallel.
- Under voltage lockout at 2.9v. .
- Blue LED when firing. .
- Provision for easy installation of remote switch. .
- Tested down to 0.15ohm builds on 2P .
- 4 mount points which can be removed to make it ultra tiny. .
- Rated at 35A - 45A
- Zero idle drain
- Onboard LED
- Smooth vaping experience
- 1S to 4S compatible (2.7v to 18v)
- The new board from Etileno. Now also with display
- For 2, 3 or 4 batteries (2S, 3S, 4S) and up to 40 amps
- Protection functions: Reverse polarity, low battery, short circuit, 10s automatic shutdown, vaporizer no contact
- Control via button or potentiometer possible
- Operation without display possible .
Items 1 - 6 of 6